Clipsal 5800WCGA Informations techniques télécharger pdf (Page 36)

TECHNICAL INFORMATION

228

C-Bus Learn Units Quick Programming Guide

4. Setting C-Bus2 Movement Sensors to Control the Chosen Electrical Loads

Using a screwdriver, change the light level setting on the

bottom of the C-Bus2 Movement Sensor.

Wait for the indicator to double flash (after 5 seconds)

then immediately (within 1 second) turn the adjusting

trimpot back the other way.

The red indicator behind the Sensor Window will then come

on and stay on. The unit is now ready to learn its time out.

Note: If the indicator stays off then go back to the first step.

Changing the setting again will cause the indicator to begin

double flashes.

Exit Learn Mode by pressing any toggle switch on a Relay

or Dimmer Output Unit for 2 seconds.

C-Bus2 will now Learn the relationship and will return to

normal operation.

Each double flasah represents a 5 minute timer duration.

The red indicator behind the Sensor Windor will flash once.

Indoor Sensor Outdoor Sensor

Turn the adjustment trimpot back the other way. The indicator will single flash showing that a timer

function has been set.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 45 46

Pas de commentaire

Clipsal 5800WCGA Informations techniques Page 36