Clipsal C-Bus Manuel d'instructions télécharger pdf (Page 135)

1250SM0904R10/09 C-Bus™ Basic Programming

10/2009 C-Bus™ Products Training Course

To create a scene:

1) Select the relevant scene number in the Scenes section of the Scene

Manager.

2) Navigate to the Available Groups and double click on the group

address you want to add to the scene.

3) Adjust the slider to set the level that you want the group address to go

to once the scene is set.

4) Repeat this process for all of the group addresses you need in the

scene.

5) Click the OK button, and then save and exit.

Figure 115 - A completed scene

Now when you press Button 1 of the Neo, the scene will be set.

NOTE: You can’t turn off the scene from the same button. Scenes may only

be set, and they cannot be toggled ON and OFF. If you want to turn the

scene off, a second scene with the same group addresses (all of which are

set to Level 0%), must be created and stored in a different button.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 147 148

Pas de commentaire

Clipsal C-Bus Manuel d'instructions Page 135