Clipsal C-Bus Manuel d'instructions télécharger pdf (Page 95)

1250SM0904R10/09 C-Bus™ Basic Programming

10/2009 C-Bus™ Products Training Course

Transferring Database to Network

Once all of the C-Bus units in the database have been programmed, the

Toolkit software can transfer the database programming information into the

physical C-Bus network.

NOTE: This is not the only way to program C-Bus units, however this

programming method requires less time programming on site. This is

achieved by doing the majority of the programming in the comfort of your

office.

To transfer the Database to the Network, follow the steps below:

1) Scan the C-Bus network.

2) Ensure that all of the unit addresses and unit types are identical in

both the network and database. E.g. That at Unit Address 003 in the

network and database, there is a DIN Rail 12 Channel Relay etc.

3) Navigate to the Units In Database toolbar in the Programming

window, and click on the small arrow to the right hand side of the

Transfer to Network button. This will display more buttons related to

transferring programming to C-Bus units. Click on the All to Network

button and the form below will appear, and the transfer process will

begin.

Figure 67 - Transfer All Unit Programming to Network form

4) Once the transfer process has completed, click on the Close button to

close the Transfer All Unit Programming to Network form.

5) The contents of the database will now have been transferred into all

the C-Bus units on the network.

6) Test and commission the C-Bus network to ensure that it is working

as expected.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 147 148

Pas de commentaire

Clipsal C-Bus Manuel d'instructions Page 95