Clipsal C-Bus Manuel d'instructions télécharger pdf (Page 92)

C-Bus™ Basic Programming 1250SM0904R10/09

C-Bus™ Products Training Course 10/2009

Readdressing C-Bus Units

Typically after scanning a C-Bus Network for the first time, you will notice

that the unit addresses in the database does not match the unit addresses

on the network.

Readdressing C-Bus units is used to align the unit addresses of C-Bus units

in the network and database. This is particularly important, as it is a

contributing factor that will allow the full database to be downloaded into the

network.

To transfer the database to the network, there are two parameters that must

be identical between the network and database:

 the unit address

 the unit type.

An identical network and database will ensure that the correct programming

information is downloaded to the correct unit on the C-Bus network.

There are two common methods used to align the unit addresses between

the network and database:

 manually readdressing each C-Bus unit to match the database

 automatically readdress to match by serial numbers.

Readdress To Match Database

To readdress the unit address of a C-Bus unit on the network to match the

database, follow the steps below:

1) Scan the C-Bus network.

2) Select a single C-Bus unit in the network.

3) Navigate to the Units on Network toolbar in the Programming window,

and click on the small arrow to the right hand side of the Readdress

button. This will display more buttons related to readdressing C-Bus

units. Click on the Readdress to Match Database button and the form

below will appear.

Figure 64 - Readdress Physical Unit form

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 147 148

Pas de commentaire

Clipsal C-Bus Manuel d'instructions Page 92